Pro Boat PRB3300S - Manual (Page 6)

6
EN
Install 4 AA alkaline batteries into the
transmitter, following the instructions
provided for your radio system.
Carefully remove the hatch from the hull.
The Pro Boat water-cooled ESC comes
pre-wired with a Deans-style connector.
Use 2 6-cell battery packs listed below for
optimum performance.
• PRB3316 7.2V 5100mAh
w/Deans Connector
You may also use 2 7.4V LiPo battery
packs (DYN5360D) to operate the boat
but you must program the esc to change
the cut-off voltage to the appropriate
level or damage to the batteies will occur
from over discharging. See Section 8 for
details.
Note: Low quality or unmatch battery
packs will not deliver the amount of
power necessary to operate this model.
If the batteries are fully charged and
the esc stops operation early, the most
likely cause is batteries with high internal
resistance. Use only high performance
batteries.
Pro Boat offers a charge adapter
(PRB3312) to allow you to charge the
PRB3316 batteries with Deans connectors
with conventional chargers that use
Tamiya-style connectors.
Follow the instructions included with your
fast charger to ensure a safe charge.
Attach the hook and loop material to the
batteries and the battery boxes. Install
two fully charged 7.2V Ni-MH battery
packs into the hull.
Section 2: Installing the Transmitter Batteries
Section 3: Installing the 7.2V Ni-MH Battery Packs