Pro Boat PRB3300S - Manual (Page 9)

9
EN
The ESC in your Blackjack 26 SS
Brushless EP is pre-programmed from the
factory. The programming is set for Ni-MH
batteries as shipped with your
Blackjack 26 SS.
A programming module (PRB3311) is
available to change the programming
of your speed control. Settings include
Ni-MH or Li-Po batteries, cutoff voltage
settings, cutoff type, brake on or off,
motor timing and throttle curve.
CAUTION: It is imperative
that you do not attempt to use
Li-Po batteries in the Blackjack 26
SS Brushless unless it has been
properly programmed or serious
damage to the batteries and
electronics may occur.
Test the radio system for proper
operation and then carefully place the
boat in the water. Pilot the boat at slow
speeds, staying close to the shoreline
to ensure you have good control and
that the boat is functioning correctly. Be
certain to avoid all objects in the water at
all times.
Once you feel comfortable with the
control of your boat, it is safe to go
further away from the shoreline and at
faster speeds. When you notice the boat
beginning to lose speed, bring the boat
back to shore. It will be necessary to
allow the electronic components to cool
down and to replace or recharge the
battery before heading out again.
Section 7: Testing Your Boat in the Water
NOTICE: Do not turn off the
transmitter first or the receiver
may pick up stray signals and run
out of control.
Section 8: Speed Control Programming
Before and at the end of each run, make
sure all screws are tight and the propeller
is free from any entanglement.
Section 9: Maintenance