Section 6: testing your boat in the water, Section 7: handling adjustment – Pro Boat PRB3900 User Manual

Page 8

Advertising
background image

8

Make sure the radio is "ON" and the

batteries are plugged into the speed

controller. Test the radio system for proper

operation and then carefully place the boat

in the water. Pilot the boat at slow speeds,

staying close to the shoreline to ensure

you have good control and that the boat is

functioning correctly. Be certain to avoid all

objects in the water at all times.

Once you feel comfortable with the control of

your boat, it is safe to go further away from

the shoreline and at faster speeds. When you

notice the boat beginning to lose speed, bring

the boat back to shore. It will be necessary to

allow the electronic components to cool down

and to replace or recharge the battery before

heading out again.

Operate your WidowMaker 22 Brushless EP

in low to medium wake conditions to avoid

having problems with the boat overturning.

If the conditions are questionable, adjust the

prop strut down a bit to reduce the likelihood

of having the boat overturn. The motor

mount is slotted to allow you to move the

motor slightly when adjusting the propeller

strut. Loosen the motor mounting screws

when adjusting the propeller strut angle and

retighten after adjustment is complete.

You may also turn the dual rate dial

down to reduce rudder travel in rough

water conditions.

Section 6: Testing Your Boat in the Water

Section 7: Handling Adjustment

Steering Dual

Rate

Loosen to

Adjust

Propeller Strut

Advertising