PS Engineering PDA360EX Installation Manual - Manual (Page 13)

PS Engineering Inc. ®
PAR100EX Audio Selector Panel and Intercom System
Installation and Operator’s Manual
200-760-0000 Page 2-6 Rev. 12, Jan. 2014
Step 1 Place nut, washer and gasket over cable and strip jacket to 5/16” (7.9 mm).
3/32”
Step 2 Comb out braid and fold out. Trim insulation off center conductor to 3/32” (2.4 mm). Tin center
conductor.
Step 3 Pull braid wires forward and taper toward center conductor. Place clamp over braid and push back
against cable jacket.
Step 4 Fold back braid wires as shown, trim to proper length [approximately .1/8” (3.2mm) long] and
form over clamp as shown. Braid wire should not extend beyond step of braid clamp. Solder contact to
center conductor, sliding the bushing first (when supplied) over center conductor.
Step 5 Insert cable and parts into connector body. Make sure sharp edge of clamp seats properly in gas-
ket. Tighten nut to approximately 15 inch pounds.
2.6 TELEPHONE (Duplex) Function for Bluetooth ® capable Cell Phones
The TELEPHONE mode in the PAR100EX is also compatible with cellular telephones with Bluetooth®.
hands-free headset interface. There is no wiring required, all functions are handled in the Bluetooth tele-
phone.
The PAR100EX Bluetooth® interface is always “discoverable”, so you just need to search for the
PAR100EX from your Bluetooth-equipped phone or music source. The default access code is 0000, if
needed. Once the PAR100EX has been “paired” with your Bluetooth device.
The telephone is distribution as dictated by the ISO, ALL, CREW.
ISO mode - only the Pilot is on the telephone.
CREW mode - only the Pilot and Copilot are on the telephone.
ALL mode - everyone is on the telephone.
You can answer a call when you hear the “telephone ringing” in your headset. To answer the phone call
will require you to have access to your phone and selecting the answer function of that telephone. There is
no front panel button that will allow you to answer the phone.