Blinking indicators – PS Engineering PMA8000D Pilot’s Guide User Manual
Page 13
202-890-0304
Page 13
Oct. 2014
PMA8000D Pilot Guide
To hear an earlier message, hold the COM RCV button until playback
stops again, and then press again to begin playing the next earlier mes-
sage. Repeat until you hear the message you wanted. Incoming new
messages will stop playback, and you can then restart.
A remote playback switch may also be installed.
Note: when you switch from one transmitter to another, the recordings
are lost. Playback is only heard by the crewmember from their audio
panel.
Blinking indicators
This chart shows you what the blinking LEDs mean.
COM 1 or COM 2 XMT
Every 1 second
Pilot or copilot is transmitting
COM 1 or COM 2 RCV
Every 3 seconds
Monitor mode activated
ISO mode in ICS
Every 3 seconds
Pilot has music in ISO
Mute and SPR buttons
Every 1 second
PA Mode active
What is blinking?
How often?
What it means