Programmable features, Electronic vehicle information center (evic), Key fob programmable features – Ram Trucks 2012 С/V - User Guide User Manual

Page 75: Electronics

Advertising
background image

PROGRAMMABLE FEATURES

Electronic Vehicle Information Center (EVIC)

• The EVIC can be used to program the following Personal Settings. Press and

release the MENU button until Personal Settings displays, then press the DOWN
button

to scroll through the settings. Press the SELECT button

to change

the setting.

• Language

• Rain Sensing Wipers

• Nav-Turn By Turn

• Key-Off Power Delay

• Enable/Disable the Rear Park Assist

System

• Illuminated Approach

• Auto Unlock Doors

• Flashers with Sliding Door

• Remote Unlock Sequence

• Hill Start Assist (HSA)

• RKE Linked To Memory

• Easy Exit Seat

• Remote Start Comfort Sys.

• Tilt Mirror In Reverse

• Horn With Remote Lock

• Blind Spot Alert

• Flash Lamps With Lock

• Calibrate Compass

• Headlamp Off Delay

• Compass Variance

• Headlamps with Wipers (Available

with Auto Headlights Only)

• Turn Menu Off

• Intermittent Wiper Option

Key Fob Programmable Features

• The following features may also be programmed by using the Key Fob transmitter

or the ignition switch and driver's door lock switch.

NOTE: Pressing the LOCK button while you are inside the vehicle will activate the
Vehicle Security Alarm. Opening a door with the Vehicle Security Alarm activated will
cause the alarm to sound. Press the UNLOCK button to deactivate the Vehicle Security
Alarm.

Unlock On First Press

• To unlock either the driver's side, or all doors, on the first press of the UNLOCK

button:

• Press and hold the LOCK button for at least 4 seconds, but no longer than

10 seconds. Then, press and hold the UNLOCK button while still holding the
LOCK button.

• Release both buttons at the same time.

Auto Unlock Doors On Exit

• To have all of the vehicle doors unlock when any door is opened:

• Enter your vehicle and close all the doors.

• Cycle the ignition switch between LOCK and ON and then back to LOCK four

times, ending up in the LOCK position (do not start the engine).

• Press the power door UNLOCK switch to unlock the doors. A single chime will

indicate that programming is complete.

ELECTRONICS

73

Advertising