Ram Trucks 2014 3500 - User Guide - Manual (Page 138)

PICKUP BOX
• You can carry wide building materials (sheets of plywood, etc.) by building a raised
load floor. Place lumber across the box in the indentations provided above the
wheel housings and in the bulkhead dividers to form the floor.
• There are stampings in the sheet metal on the inner side bulkheads of the box in
front of and behind both wheel housings. Place wooden boards across the box from
side to side to create separate load compartments in the pickup box.
• There are four tie-down cleats bolted to the lower sides of the pickup box that can
sustain loads up to 1000 lbs (450 kg) total.
Cargo Camera
• Your vehicle may be equipped with the Cargo Camera that allows you to see a
image of the inside of the pickup box. The image will be displayed in the
Uconnect
® screen.
• A display timer is initiated when the cargo camera image is displayed. The image
will continue to be displayed until the display timer exceeds 10 seconds and the
vehicle speed is above 8 mph (13 km/h) or the image is deactivated by touching
the Uconnect
® display.
NOTE:
If the vehicle speed remains below 8 mph (13 km/h), the cargo camera image will be
displayed continuously until deactivated by touching the Uconnect
® display.
• The Cargo Camera is located in the bottom center area of the center high-mounted
stoplamp (CHMSL).
NOTE:
If snow, ice, mud, or any foreign substance builds up on the camera lens, clean the
lens, rinse with water, and dry with a soft cloth. Do not cover the lens.
UTILITY
136