Ram Trucks 2014 3500 - User Guide - Manual (Page 69)

5. Wait for the beep and say a contact that is in your phonebook, or a mobile phone
number that you would like to send the message to.
6. Uconnect ® will prompt you “Please say the message that you would like to send.”
(If you do not hear this prompt, you may not have an active subscription with
Uconnect
® Access).
7. Wait for the beep, and then dictate any message up to 140 characters. If you
exceed 140 characters, you will hear the following prompt: “Message was too
long; your message will be truncated.”
8. Uconnect ® will then repeat the message back to you.
9. Uconnect ® will prompt you: “To add to your message, say “Continue”; To delete
the current message and start over, say “Start Over”; to send the current message,
say “Send”; to hear the message again, say “Repeat”.
10. If you are happy with your message and would like to send it, wait for the beep
and say “Send”.
11. Uconnect ® will then say “Sending your message.”
Sample Commands For Voice Text Reply And Voice Texting
Example Command Action
“Text John Smith”
Send a message to specific contact in
address book
“Text 123 - 456 - 7890”
Send 123 - 456 - 7890 a message from
your phonebook
“Show messages”
See recent text messages listed by num-
ber on Uconnect ® screen
“Listen to/view
(message number four, for example)”
Hear messages or read it on Uconnect ®
screen
“Reply”
Send a voice text reply to a current mes-
sage
“Forward text/message to “John Smith”
Forward current text to specific contact in
address book
“Forward text/message to
“123 - 456 - 7890”
Forward current text to specific phone
number
ELECTRONICS
67