Sceptre X46BV-FULLHD - Manual (Page 33)

SCEPTRE X46 HDTV User Manual
- 33 -
www.SCEPTRE.com
Connecting Your
Satellite or Cable
Set-top box to the
TV
If You Want the Best Connection
with HDMI…
1. Make sure the power of X46 LCD HDTV and your set-top box is turned off.
2. Connect a HDMI cable to the HDMI output of your set-top box and the other end to the
HDMI port off the back of your X46 LCD HDTV.
3. Turn on the X46 LCD HDTV and your set-top box.
4. Use the remote control’s source button or the source button on the right side of the TV to
switch to HDMI 1.
Please Note :
• Please reference the set-top box’s manual, to make sure the set-top box is
configured to output correctly to the TV.
• If HDMI 1 is already occupied, please use HDMI 2 as your connection port and
switch source to HDMI 2.
• This TV does not decode Bitstream digital audio, therefore you’ll need to make
sure your DVD is setup for PCM digital audio through HDMI.
• You can also use HDMI 3 on the side of the TV as an alternative as well.
• Sceptre’s X46 LCD HDTV supports SONY’s universal remote code. Please
look up SONY’s codes in your universal remote’s hand book.
• This TV will turn off automatically if there’s no signal present for more than 15
minutes.