SeaLand DTMF04 Freshwater Tank Monitor - Manual (Page 9)

9
Dometic Freshwater Tank Monitor Specifications
5.3 Dimensions (fig . 2 , page 2)
Ref. Dimension
A 83 mm / 3 .25 in .
B 83 mm / 3 .25 in .
C 51 mm / 2 in . clearance behind wall
D 10 mm / 0.38 in.
Ref. Dimension
E 111 mm / 4 .375 in .
F 25 mm / 1.0 in. (if applicable)
G 527 mm / 20.75 in.
H 69 mm / 2 .75 in .
5.4 Approvals
ISO 8846; EMC Directive 2004/108/EC; CE approved for electromagnetic compatibility
6 Installation
6.1 Tank Monitor Panel (fig . 3 A, page 2)
Caution!
Do not install DTMF04 panel in an atmosphere with potentially flammable or explosive
vapors .
1 . Select panel location away from direct contact with water
and oil .
2 . Confirm clearance for wire connections behind wall, hull
liner or bulkhead .
3. Using control panel template (fig. 6 , page 5), cut out panel
access hole (E, F) and drill fastener holes (G) .
4 . With electrical power off, route 18-gauge stranded copper
wire from power source, through circuit breaker or fuse (not
provided), to panel location . Route additional wire accord-
ing to diagram (fig .
4 , page 3 – see wiring diagram key
below), depending on your application, to panel location .
Make sure wires extend out through access hole .
5 . Make proper wiring connections to wires extending from
bottom of circuit panel (fig . 3 A 2, page 3) .
6 . Remove panel cover (fig . 3 A 1, page 3) from circuit panel/
mounting frame (A 2), if necessary, by carefully pulling them
apart .
7 . Install mounting frame to wall with four fasteners (fig . 3 A
3) .
8. Push panel cover onto mounting frame until it locks.
6.2 “Empty Tank” Shut-down Relay
(optional accessory) (fig . 1 4, page 2)
1 . At step 4 (above), route and connect 14-gauge stranded copper wires according to wiring diagram
(fig . 4 , page 3) and wiring diagram key (see section 6 .4) .
2 . Remove circuit panel housing from circuit panel (fig . 1 5, page 2), and insert “Empty Tank” shut-
down relay into receptacle on back of circuit panel . Re-attach circuit panel housing .
DTMF04 Panel Template
Dimensions
(fig . 6 , page 5)
Ref. Dimension
A 83 mm / 3 .25 in .
B 83 mm / 3 .25 in .
C 67 mm / 2 .63 in .
D 67 mm / 2 .63 in .
E 55 mm / 2 .16 in .
F 68 mm / 2 .69 in .
G 2 mm / 0.10 in. dia.
H Cut-out area .
Allow 51 mm / 2 in .
clearance behind
wall .