2general safety instructions, 3intended use, 4 installation – SeaLand DVF1619 Vent Filter User Manual

Page 3

Advertising
background image

3

Caution!
Do not use Dometic

®

Vent Filter for holding tanks with waste that is treated through on-

board sewage treatment systems that use chlorine or other strong oxidizing agents .

Install new filter

1 . Select location for vent filter . Avoid areas near excessive heat sources (engine manifolds, lights, etc .) .

Do not install filter below top of holding tank (fig . page 2) .

2 . Vent filter can be mounted at any angle . Installations near thru-hull vent reduce chance of filter

damage from potential overfilling of tank .

3 . Install mounting bracket (fig . 1, page 2) with fasteners (fig . 2, page 2) .

4 . Press vent filter (fig . 6, page 2) into mounting bracket .

5 . Install 5/8-inch or 3/4-inch (16 mm or 19 mm) hose adapters (fig . 4, page 2)

on both ends of

filter, making sure rubber gaskets (fig . 5, page 2) are in place . Tighten 1/4 to 1/2 turn beyond
hand tight .

6 . Using hose clamps (fig . 3, page 2) (not included with vent filter), install 16 mm or 19 mm

(5/8-inch or 3/4-inch) I .D . vent hoses (fig . 2, page 2) from holding tank and thru-hull fitting
(fig . 1, page 2) to hose adapters on filter .

Remove old filter
(if replacing existing vent filter)

1 . Remove vent hose from both ends of old vent filter .

2 . Remove old filter from bracket and seal ends with caps that are provided with new filter .

3 . Discard old filter in appropriate container .

2

General safety instructions

The manufacturer will not be held liable for claims for damage resulting from the following:

• Faulty assembly or connection

• Damage to the unit from mechanical influences

• Alterations to the unit without express written permission from the manufacturer

• Use for purposes other than those described in the operating manual

Dometic Vent Filter

General safety instructions

3

Intended use

When a toilet is flushed on a boat with a holding tank, air is pushed out of the holding tank, through
a vent hose, and out of the boat through a vent fitting . To stop foul-smelling air from coming out of
the vent fitting, install a Dometic Vent Filter .

4 Installation

1

2

2

Caution!
Replace vent filter immediately if accidental overflow of holding tank occurs.

Note
Replace vent filter at the beginning of each boating season for best odor control .

3

3

3

3

3

3

Advertising