SeaLand 111 Toilet - Manual (Page 2)

2
To prepare the Dometic toilet for use, check to be sure water supply to the toilet is
connected . Turn on water supply and check system for leaks . Flush toilet and check for leaks .
To properly use the Dometic toilet, follow these simple instructions:
1 . To add water to the toilet, lift or raise
the flush pedal until desired water level
is reached . Generally, more water is
required only when flushing solids .
2 . To flush toilet, push pedal all the way
down until contents leave toilet bowl .
Water flow pressures vary at different
locations, therefore holding the flush
pedal down for 4-8 seconds may be
required . Minimum flow at the toilet of
two gpm (7 .6 lpm) is required for proper
rim and bowl wash .
3 . Release flush pedal by allowing it to snap back,
which permits positive sealing around the flush ball .
4 . A small amount of water should remain in bowl .
Note
Holding flush pedal down longer than necessary results in excessive water use .
1 . Do not use chlorine or caustic chemicals, such as laundry bleach or drain-opening types, in
the system . These products damage the seals in toilets and dump valves .
2 . Do not permit foreign objects (paper towels, paper cups, diapers, sanitary napkins, etc .) to
be flushed through the toilet .
3 . Mechanical seal toilets, like Dometic units, are designed to only discharge directly into
a holding tank . Horizontal pipe runs as found in conventional residential or commercial
plumbing systems cannot be accommodated .
4 . Toilet bowl must be regularly cleaned and winterized according to “Cleaning” and
“Winterization and Storage” procedures or your warranty coverage may be voided .
General Safety Instructions
Operation
Toilet Model Identification
The model identification label is located on
the toilet base under the pedestal cover
and will show the model number and serial
number . Remove base cover to locate
identification label (see page 5) .
Caution!
This manual must be read and understood before adjustment, maintenance or service is
performed . Modification of this product can result in property damage .