SeaLand 111 Toilet - Manual (Page 3)

3
Installation
1 . To replace an older toilet, turn off water supply to toilet .
Disconnect water line at toilet water valve . Unscrew floor bolt
nuts and remove toilet . Discard old floor seal and mount-
ing bolts . The old floor flange may be used if it is in good
condition and has fastener holes that are positioned correctly .
Make sure center of floor flange is at least 11 inches
(279 mm) from back wall (Figure A) .
NOTE: If old floor flange cannot be used and cannot be
removed, please use a SeaLand Universal Mounting Kit,
available from your Dometic dealer .
2 . When installing new floor flange, make certain that the toilet
mounting bolts align properly with Dometic toilet mounting
pattern .
3 . Secure flange to floor using flat head screws through
countersunk holes in flange . Insert floor bolts into slotted
holes in flange (Figure B) .
4 . If toilet is being installed in a shower stall, apply a 1/4" thick
by 3/4" wide bead of glazing compound around the circum-
ference of the floor flange (Figure C) .
5 . Dometic toilet models 111, 510 and 511 will accept handicap
or household decorative seats . Remove existing seat and
replace with new seat if desired .
6 . Position floor seal by pressing the floor bolts up through
holes in the seal .
7 . Set toilet in place with bolts protruding up through mounting
holes in base (Figure D) .
8 . Install washers and hex nuts provided with toilet . Tighten
nuts down equally with standard 7/16" open end wrench .
Remove excess glazing compound from around base in
shower stall installation .
9 . Connect water supply line to water valve (1/2" NPT) inlet
using appropriate fittings or an extension (Figure E) .
10 . Turn on water supply and flush toilet to test for leaks .
11 . Attach pedestal and pedal covers to toilet base
(see instructions below) .
Fig. F
Attaching Pedestal and Pedal Cover
2. Tall model – screw
cover together. Short
model – snap together.
1. Wrap pedestal cover
around base so that it
closes as shown.
3. Slide pedal cover onto
foot pedal rod.
4. Secure side plate onto
pedal cover
with screws.
Fig. B
Fig. D
Fig. E
Fig. A
Fig. C