SeaLand 8700 Series MasterFlush Toilet Installation - Manual (Page 10)

10
Dometic 8700 Series MasterFlush Toilet Installation
5.4 Toilet system with flush handle and through-the-floor connections
- all applications
1 . Follow steps 1-3 in Section 5 .3 .
2 . Plan electronic control module and status panel locations so that electrical connections can be
made with cables provided. Be sure module and wires cannot get wet.
3. Use Dometic wall switch template to mark location of fastener and access holes for status panel
(fig. 1 M, page 2). Drill wiring access hole, then fasten panel bracket to wall.
4. Route flush handle/status panel cable (fig. 1 N, page 2) from control module location to toilet
and status panel. Route Dometic flush handle cable section (with orange connector) to access
hole at toilet location . Route other section of cable through status panel access hole and
connect to status panel wire . Attach status panel to panel bracket on wall .
5. Install control module in cool, dry location, then attach Dometic flush switch/status panel cable
to control module (fig. 18 ).
8 . With electrical power off, complete wiring connections to control module . Refer to Section 5.7,
Wiring schematic - Dometic flush handle and status panel .
9. Route 4-wire control module cable (fig. 1 D, page 2) to toilet through access hole in floor.
10. Route water supply and discharge plumbing to toilet according to system requirements (Section
4.2). Make sure to provide extra discharge hose length to assure easy connection to toilet
(fig.
19 ).
11 . Follow steps 11-13 in Section 5 .3 to connect discharge plumbing and 4-pin connector at toilet .
12. Connect 3-pin flush handle cable connector to 3-pin wire from control module (fig.
20 ).
13. Follow steps 14-17 from Section 5.3 to finish installation and testing. Press flush handle down
when testing operation and checking connections .
18 20 19