SeaLand 8700 Series MasterFlush Toilet Installation - Manual (Page 8)

8
Dometic 8700 Series MasterFlush Toilet Installation
5.3 Toilet system with wall touchpad and through-the-floor connections
- all applications
1. Place floor mounting template in desired location (fig. 8 ). For optimal user comfort, make sure
walls or other interior fixtures are at least 11 in. (279 mm) away from centerline of template.
2 . Center punch all holes through template .
3. Remove template from floor. Drill all access holes as indicated on template (fig.
9 ).
4. Plan flush switch panel and electronic control module locations so that electrical connections can
be made with cables provided. Be sure module and wires cannot get wet.
5. Use Dometic wall switch template to mark location of fastener and access holes. Drill 1 in.
(25 mm) hole, then fasten panel bracket to wall (fig. 10 ).
6. Route Dometic flush switch panel cable from control module to access hole at flush switch panel
location. Attach cable to flush switch panel, then snap the panel cover onto the panel bracket
(fig.
10 ).
7. Install control module in cool, dry location, then attach Dometic flush switch cable to control
module (fig. 11 ).
8 . With electrical power off, complete wiring connections to control module . Refer to Section 5.6,
Wiring schematic - Dometic flush touchpad or Vimar/Gewiss controls .
9. Route 4-wire control module cable (fig. 1 D, page 2) to toilet through access hole in floor.
10. Route water supply and discharge plumbing to toilet according to system requirements (Section
4.2). Make sure to provide extra discharge hose length to assure easy connection to toilet
(fig.
12 , page 9).
8 9 10
Note
When installing Vimar or Gewiss flush switch/status panel,
disregard instructions for installing Dometic touchpad switch.
Install Vimar or Gewiss component on wall according to
manufacturer’s instructions, then attach end of cable to 6-wire
connector (fig.
1 D, page 2) at control module.
11