Shellab SCO10W-2 - Manual (Page 15)

15
DATA LOGGER FUNCTION
The data logger provides ways to externally indicate or log all the incubator front panel displays at intervals
ranging from 1 to 99 minutes. The logger contains a real time clock/calendar to date and time stamp each
logged reading.
The logger indicates and logs all front panel display readings in single lines of text. This data is logged when
the present logging interval has expired or one of the monitored displays has changed its alarm state. Logged
data has a time and date field that corresponds with the logger
’s real time clock.
This logged data can be externally accessed through ports provided on the front of the incubator for serial and
parallel functions, as well as a BNC contact closure plug for extended alarm condition(s). The parallel port is
compatible with any Epson or IBM style printer. The serial port operates at 9600 baud with 8 data bits, 1 (one)
stop bit and no parity and connects with a computer through the USB.
6.1 Program the Data Logger: Select the parameter to adjust by pressing and holding the "MODE"
button pad until the left two display digits show "LP" indicating the logger has entered the set mode.
The parameter that can be changed will blink and its value can be changed by pushing the UP or
DOWN arrow pads.
6.2 Pressing and holding the MODE pad for approximately one second will cause the logger to step to the
next parameter. The table on the following page shows the indications for each parameter. If no
buttons are pressed for fifteen (15) seconds, the panel display will revert to the normal operation mode.
THE CONTROL PANEL DISPLAYS
SIX PARAMETERS, SHOWN BELOW, WHICH CAN BE CHANGED USING THE
CONTROL PANEL BUTTONS
FRONT PANEL MODE LEFT TWO DIGITS RIGHT TWO DIGITS COLON
NORMAL OPERATION SHOW HOURS OF CURRENT 24 HR
TIME
SHOW MINUTES OF CURRENT
TIME
BLINK
SET LOGGING PERIOD SHOW "LP" BLINK LOGGING INTERVAL IN
MINUTES. CAN BE VERIFIED
FROM 0-99 MINUTES .
OFF
SET HOURS BLINKS HOURS PORTION OF
CURRENT TIME. CAN BE VARIED
FROM 00 TO 23
ARE BLANK ON
SET MINUTES ARE BLANK BLINK MINUTES PORTION OF
CURRENT TIME. CAN BE VARIED
FROM 0 TO 59
ON
SET MONTH BLINK CURRENT MONTH. CAN BE
VARIED FORM 1 TO 12
ARE BLANK OFF
SET DATE ARE BLANK BLINK DAY OF MONTH. CAN BE
VARIED FROM 1 TO 31
OFF
CURRENT YEAR "19" OR "20" BLINK LOWER 2 DIGITS OF YEAR OFF
6.3 The data logger clock has a back up battery. The recommended replacement is Panasonic 3 Volt, 165
mA # BR2325 type 1HB, 1HC, OR 1HG.
Section
6