Shellab SRI20PF - Manual (Page 18)

Page | 18
OPERATION (CONTINUED)
Figure 10: Details of the SRI6PF and SRI20PF Controls and Displays
S ET THE C URRENT T IME
1. To change the clock to your current local time, press and release the Mode button.
2. The Current Time LED will stay lit, the Temperature Display will go out, and the Time
Display will begin flashing, displaying an adjustable time setting.
3. It will not matter if the Day or Night Temp LED’s are illuminated. Neither will affect setting
the clock.
4. Set the current time in the 24 hour clock day using the UP and DOWN arrows. 24 hour
clock PM afternoon and evening times are twelve hours greater than their normal 12-hour
clock equivalents. Example: 1 PM = 13:00; 6 PM = 18:00; 9 PM = 21:00. 12 AM will be
00:00. 12 AM is the point where the 24 clock cycle starts over.
5. After adjusting the clock to local time, press and release the Enter button. This will enter
your selected time into the incubator as the Current Time. It will also automatically advance
the unit to the Day Time phase Start Point selection mode.
S
ET THE
D
AY
T
IME
P
HASE
S
TART
P
OINT
This procedure selects a time start point at which the unit will automatically switch to illuminated
Day Time phase lighting and temperature operations when running in the Auto Cycle Mode.
1. After pressing the Enter button at the end of setting the Current Time, the unit will advance
to its select Day Time Start mode. The Temperature Display will remain dark, and the Time
Display will continue to flash, displaying an adjustable Day Time start point.
2. The Current Time indicator LED will extinguish.
3. The Day Time LED indicator will turn on.
4. Using the UP and DOWN arrow keys, set the Day Time start point.
5. Press the Enter button. This will enter the Day Time phase Start Point, and automatically
advance the unit to its Night Time phase Start Point selection mode.