SilentKnight IP Communicator - Manual (Page 16)

16 IP Communicator Series Installation Document — P/N 53109:I 4/26/2010
2.4 Mounting 411 or 411UD in HP300ULX Power Supply Enclosure with
IPDACT Series
The 411/411UD can be mounted inside the HP300ULX power supply enclosure as described below.
1. Position the two mounting tabs on the 411/411UD, over the two mounting holes in the HP300ULX backbox. Use
dimensions and the landmarks illustrated in Figure 16 to locate the correct mounting location.
2. Secure the 411/411UD to the backbox by installing the supplied screws into the top and bottom mounting tabs of the
411/411UD and tighten. Refer to Figure 17.
3. Install the IPDACT Series in the HP300ULX enclosure as described in Section 2.3 of this document.
411/411UD
mounting
holes
Figure 16 411/411UD Installation
HP
30
0
U
LX
in
st
a
ll4
1
1
UD.wm
f
411/411UD DACT
mounting tab
mounting tab
Figure 17 411/411UD Installation
HP
30
0U
LX
in
st
a
ll4
11
UD2
a.wm
f