Way wireless rf touchpanel crestron st-1700c – Crestron electronic ST-1700C User Manual
Page 16
1-Way Wireless RF Touchpanel
Crestron ST-1700C
NOTE: If the control system in use has a 4-pin network connector rather than a
modular (RJ11-type) NET connector, use a ST-CBL (sold separately).
NOTE: To make a cable for either configuration, refer to the “Programming Cable
Specifications” diagram after these notes.
NOTE: The RJ11 (part of ST-PK) and ST-CBL cables can also be found as part
numbers CNSP-585 and CNSP-586, respectively, in the Crestron cable database. The
database can be downloaded from the Downloads | Software Updates | Cables section
of the Crestron webs
Programming Cable Specifications
CONNECTOR, 6 PIN, RJ11
(TAB FACING AWAY)
1
2
3
4
5
6
BLACK
RED
SHIELD
- OR -
Y
Z
G
1. Before making any connections to the touchpanel, verify that control system is
properly connected to the PC (using ST-PK cable 15717 and adapter) and
powered on.
2. Attach the stereo connector end of the ST-PK cable 15710, to the touchpanel.
3. Attach the RJ11 connector end of the ST-PK cable 15710, to the connector
labeled NET on the control system.
4. Attach the appropriate external power pack or equivalent to touchpanel and
plug into outlet. At the PC, make sure that no programs accessing the COM
port of the PC are running.
5. Start VT Pro-e.
6. From the e menu bar, select Tools | Viewport to open the Crestron Viewport.
NOTE: SIMPL Windows may open with a splash screen and may display the “What
do you want to do?” window. If so, close the window and continue.
12
• 1-Way Wireless RF Touchpanel: ST-1700C
Operations Guide – DOC. 6050