Sonics X-Press Integrated Welder - Manual (Page 15)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L X - P R E S S
14
5. ENERGY key (active on XPE models only) which allows selection and
display of the following energy settings and permits adjustment of the
energy parameters a. through c. below in 1 joule increments (from 0 to
999,999 joules):
a. Energy Setting
b. Energy Limit Low
c. Energy Limit High
For a complete explanation of these parameters, refer to page 19.
6. AMPLITUDE key which controls adjustment of the amplitude setting,
relating to the system’s high-frequency vibrations over the full operating
range. Refer to page 19 for more information. (Major adjustments of
amplitude can be made through the use of different boosters – see page
27.)
7. FN KEY. Option not available on this model.
8. TEST key which can be used to test ultrasonic operation and displays
idle losses of converter/booster/horn as a percentage of maximum power
when key is depressed. Also functions as a frequency display. Refer to
page 16 for more detailed information.
9 O.L. RESET key which resets the power supply following an overload
condition. Red LED in upper left corner indicates an overload condition
exists. Refer to page 20 for complete information.
10. 0-9 NUMERIC KEY PAD which allows input of numeric data or
numeric selection options by pressing the keys.
11. CLEAR key which cancels a prior parameter value when a new value is
to be entered.
12. ENTER/REVIEW key which Enters data into the system as keyed in with
the numerical keys and displayed on the LCD screen. In Review function,
displays the alarm, mode and cycle information.
Go To Top Of Document