SunBriteTV 5510HD - Manual (Page 11)

SunBriteTV Model 5510HD Operator’s Manual Page 11
TV Installation – Rear Panel Connections/Connection Diagrams
Switching Sources for Ports:
Model 5510HD off ers several options when connecting
your devices to the TV. The chart below will help you
understand which source you switch to for each of the
ports.
CONNECTING TO AN ANTENNA
1. Make sure the power to the TV is turned off .
2. Connect the Coaxial RF cable from your
antenna or digital cable to the ATSC/NTSC port off
the back of your the TV.
3. Turn on the TV.
4. Select TV (Air) for antenna or TV (Cable) for
digital cable from either your remote control’s
source button or source button on the right side
of the TV.
5. Use the On-Screen Display to scan for channels.
Connecting to Digital Cable without Cable Box or Antenna Connecting to Cable or Antenna
1. Make sure the power of the TV is turned off .
2. Connect the Coaxial RF cable from your
antenna or cable to the
ATSC/NTSC port off the back of your TV.
3. Turn on the TV.
4. Select TV (Air) for antenna or TV (Cable) for
cable from either your remote control’s source
button or source button on the right side of the
TV.
5. Use the On Screen Display to scan for channels.
Note: Some VCRs must be turned on before output
will have a signal to the TV.
Please Note :
1. Not all broadcasts are in High Defi nition (HD). Please refer to your local broadcasting stations for more information.
2. The TV’s tuner is designed for HDTV therefore requires a stronger signal than normal TVs. If you cannot achieve that signal
level with your antenna or cable, your 5510HD might lose picture or sound.
3. This TV will turn off automatically if there’s no signal present for more than 15 minutes.