SunBriteTV 5510HD - Manual (Page 17)

SunBriteTV Model 5510HD Operator’s Manual Page 17
Connecting with RCA Audio Analog (Good) 1. Make sure the power of the TV and your PC is turned off .
2. Obtain a 15-pin D-Sub VGA cable, connect to the VGA output of
your PC and the other end to the VGA port off the back of your TV.
3. Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC
and the other end to the VGA Stereo Input port.
4. Turn on the power of the TV and your PC.
5. Use the remote control’s source button or the source button the
TV to switch to VGA.
Please Note :
1. For the best results, please set your PC resolution to
1920 x 1080at 60 Hz. Refer to the PC or graphic card’s manual for
further instructions on how to set your resolution and refresh rate.
2. Refer to your PC manual for video output requirements of the
video card.
3. The VGA port of the TV features a power saving mode which will
automatically turn off the TV if there is no signal provided for more
than 15 minutes.
TV Installation – Rear Panel Connection Diagrams
CONNECTING TO A PC (Continued)
CONNECTING TO GAME CONSOLES
For the Playstation®3
1. Make sure the power of the TV and your Playstation 3 is turned off .
2. Connect an HDMI cable to the HDMI output of your Playstation 3
and the other end to the HDMI port on the back of the TV.
3. Turn on the TV and Playstation 3.
4. Use the remote control source button or the source button on the
power panel of the TV to switch to HDMI.
Please Note :
1. Refer to the Playstation 3’s manual to make sure the PS3 is
confi gured to output correctly to the TV. PS3 by default outputs to
composite only. With newer fi rmware, PS3’s HDMI should also output a
signal. Please call PS3’s tech support for further troubleshooting.
2. This TV does not decode Bit stream digital audio, therefore you’ll
need to make sure your DVD is set up for PCM digital audio through
HDMI.
3. If HDMI 1 is already occupied, please use HDMI 2 as your
connection port and switch source to HDMI 2.
4. This TV will turn off automatically if there’s no signal present for
more than 15 minutes.