SunBriteTV 5510HD - Manual (Page 16)

Page 16
TV Installation – Rear Panel Connection Diagrams
CONNECTING TO AN EXTERNAL AMPLIFIER OR AMPLIFIED SPEAKERS
1. Make sure the power of the TV and your receiver is turned off .
2. Obtain a Coaxial SPDIF cable, connect it to your receiver’s
coaxial SPDIF digital input and the Coaxial SPDIF connection
on the LINE OUT port off the back of the TV.
3. Turn on the TV and your receiver.
Please Note :
1. If you want pure digital stream for your receiver to
decode, you must also confi gure the TV’s OSD Sound->Digital
Audio Out function. Make sure the option is on Bit Stream.
2. If your receiver is making static noises when receiving Bit
Stream, you must use the PCM option instead.
3. Refer to the receiver’s manual to make sure the receiver is
confi gured to receive signals correctly from the TV
1. Make sure the power of the TV and your receiver is turned off .
2. Obtain a HDMI to DVI conversion cable; connect the DVI side
of the conversion cable to the DVI output of your PC, and the HDMI
side of the conversion cable to the HDMI port off the back of TV.
3. Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC
and the other end to the VGA Stereo Input Port.
4. Turn on the power to the TV and the PC.
5. From the remote control’s source button, or the Source button
from the TVs panel, switch to HDMI.
Please Note :
1. For the best picture, set your PC resolution to 920 x 1080 at 60
Hz. Refer to the PC or graphic card manual for further instructions
on how to set your resolution and refresh rate.
2. Refer to your PC manual for video output requirements of the
video card.
3. The TV will turn off automatically if there’s no signal present for
more than 15 minutes.
4. If HDMI 1 is already occupied, use HDMI 2 as your connection
port, and switch source to HDMI 2.
Continued on next page
Connecting with Coaxial SPDIF Digital (Best)
CONNECTING TO A PC
Connecting with DVI Digital (Best)
1. Make sure the power of the TV and your receiver is turned
off .
2. Obtain a 3.5mm stereo/audio cable (if your amplifi er
audio connection requires RCA audio out jacks you will need
to obtain an 1/8” Stereo Mini Plug to RCA adapter cable).
Connect it to your receiver’s audio input connection and the
3.5mm stereo/audio connection on the Analog Audio port on
the back of the TV.
3. Turn on the TV and your receiver.
Please Note :
1. If you want pure digital stream for your receiver to
decode, you must also confi gure the TV’s OSD Sound->Digital
Audio Out function. Make sure the option is on Bit Stream.
2. If your receiver is making static noises when receiving Bit
Stream, you must use the PCM option instead.
3. Refer to the receiver’s manual to make sure the receiver
is confi gured to receive signals correctly from the TV
Connecting with RCA Audio Analog (Good)