TC-Helicon VoiceLive 2 User manual - Manual (Page 97)

when singing. If not, check connection and run MIC
GAIN setting procedure.
3. It's possible LEAD MUTE is enabled globally in the
Setup I/O menu, set it to OFF to change.
4. Turn off all effects, one of the effects could have
LEAD MUTE enabled.
I can't update my software
If USB is connected, check the USB CONTROL
parameter under the SETUP / SYSTEM page. If it's set to
OFF, VoiceSupport will not be able to connect to
VoiceLive 2 and upgrade your software.When it's set to
ON, you will be able to upgrade software but not be
able to use a MIDI keyboard connected to the MIDI IN
to control harmony.
MIDI Input doesn’t work
See “I can’t update my software” above.
My lead vocal is cutting out
1. Is the FX button on? Adjust the Transducer GATE
THRESHOLD to a lower value in that preset.
2. If the Tone button is on, check that if the GATE is set
to MANUAL, that the THRESHOLD is adjusted properly
for your singing style.
The edit asterisk is always on in preset names
The LEAD MUTE parameter in the Setup I/O menu may
be set to ON.
How can I reset everything?
To return all presets to factory settings, apply power
while holding the Tone, Pitch and Guitar FX buttons.
Note that this will permanently erase any user presets
you have created.
To return all System settings to factory defaults, apply
power while holding the Setup, Wizard and Store
buttons.
Where can I find support for this product?
There are three easy ways to get support:
1. Install the VoiceSupport application
2. Visit www.tc-helicon.com/support
3. Email [email protected]
FAQ and Troubleshooting
97