TeeJet CenterLine v1.05 - Manual (Page 35)

CenterLine
Software Version 1.05
CenterLine Real-Time Operation
Starting Real-time Operation
This section assumes that the setup section, —CenterLine Setup“ on page 13, has been read and
the CenterLine lightbar properly set up.
Start real-time operation by pressing Enter when <START> is displayed in the text window. The
<START> menu item is at the highest menu level. <START> can be easily reached from most
menu levels by scrolling to <TO START> and pressing Enter. This jumps to the <START> location
from anywhere in the menu structure (See Figure 28).
Figure 30 is a flow diagram of the CenterLine real-time operation and menu.
Figure 30: Real-Time Operation Flow Diagram
New? Resume?
When Enter has been pressed at the <START> location, a prompt to start a new field or resume
working in the current field appears. During real-time operation, CenterLine stores the vehicle‘s
trajectory data. This allows the operator to stop working in a field before finished and return at a
later time, continuing where they left off. Only the current field is stored.
Use Up or Down to scroll between the <NEW?> and <RESUME?> menu items. Selecting
<NEW?> clears the current field trajectory data and starts a new field in memory. Selecting
<RESUME?> retains the current field trajectory data and allows the start of guidance using the
existing data.
CenterLine
CenterLine Real-Time Operation
29