TeeJet CenterLine v1.05 - Manual (Page 9)

CenterLine
Software Version 1.05
What‘s new in Version 1.05
• The lightbar is now 15% brighter. This makes the lightbar display easier to read in bright sun-
light.
• A new lightbar display option has been added. The Steer Bar option makes the LED steering
display easier to see (See —Lightbar Setup“ on page 19).
• All text messages (not warnings, alarms, or guidance info) are now displayed for 15 seconds
when first enabled (See —Text 1 and Text 2“ on page 20).
• The Applied! message is displayed when crossing into an applied area, even if application is
turned off (See —Applied Area Detection“ on page 41).
• The Bounded Area is now displayed when stopped in an applied area (See —Area Determina-
tion“ on page 31).
• Н©И now appears in the lightbar text display to confirm that the —Return To Point“ button
was pressed (See —Return to Point“ on page 33).
• In —Return to Point“ mode, no active text messages are displayed (only error messages) (See
—Return to Point“ on page 33).
• —Return To Point“ mode now works in swath mode as well as headland mode.
• The Exit? message is now displayed to confirm desire to exit the guidance function (See —Exit-
ing Real-time Operation“ on page 33).
• A —Hollow“ path is now displayed:
• in Headland Mode, during the first headland pass, to indicate that no guidance information
is available yet (See —Headland Guidance Operation“ on page 34).
• during Straight Mode when the distance to the previously applied area is too far to deter-
mine a guidance path (See —Straight-line Guidance Operation“ on page 40).
• X-Track information is now displayed in Headland Mode (See —Headland Guidance Operation“
on page 34).
Corrections to the Ver. 1.0 User Guide
• Clarification of the connection of the Implement Status line (See —Status“ on page 17).
• Corrected Setup Flow Diagram (Added —Steer Bar) (See —CenterLine Setup Flow Diagram“ on
page 26).
• Correction of the Receiver GPS Status messages (See —Receiver“ on page 27).
• Corrected Real-Time Operation Flow Diagram ( Corrected default mode to —Straight“, changed
—Boundary“ label to —Area“, added —Apply Off?“ and —Apply On?“) (See Figure 30 on page 29).
• Clarification of default guidance mode (See —Real-time Operation“ on page 30).
• Added description of —Apply On/Off (See —Apply On/Off“ on page 30).
CenterLine
Introduction
3