TeeJet Fieldware SA 2.0 for Legacy 6000 - Manual (Page 30)

2-18 Chapter 2 - Getting Started
System Setup
Fieldware-SA for the Legacy 6000
Software Version 2.00
Setting Description
Use GPS Defines whether the Legacy 6000 system is using GPS. If using GPS, this setting must
be set to Yes.
Accuracy Defines the accuracy of the DGPS receiver. Choices are RTK and Sub-meter.
Height Enter the height of the antenna above the ground.
Com Port Defines the com port that the GPS receiver is connected to.
Baud Rate Defines the selected com port baud rate.
Data Bits Defines the selected com port data bit setting.
Stop Bits Defines the selected com port stop bit setting.
Parity Defines the select com port parity.
Table 2-7: The GPS Receiver Setup Settings