TeeJet LH INTELLITRAM 500 - Manual (Page 16)

E NCODE LH ”I NTELLITRAM ” 500 O PERATORS MANUAL
16 LH A GRO
FORWARD SPEED SENSOR
Selection of the forward speed sensor plus the speed calibration figure can be
encoded here. It is also possible to automatically calibrate the forward speed
sensor.
Key Description
Pressing this key (program key 1) selects Radar as the speed
sensor (via the 7-pin DIN/ISO socket).
If the number of pulses per 100 m is known it can be encoded
directly.
Pressing this key (program key 2) selects a wheel sensor fitted on
the tractor as the speed sensor (via the 7-pin DIN/ISO socket).
If the number of pulses per 100 m is known it can be encoded
directly.
Pressing this key (program key 3) selects a wheel sensor fitted to
the seed drill as the forward speed sensor.
If the number of pulses per 100 m is known it can be encoded
directly.
AUTOMATIC FORWARD SPEED CALIBRATION
Step/Key Description
1 Measure a 100-metre stretch and drive to the start mark.
2 Select the speed sensor as described above.
3
Press this key and drive the measured 100-metre stretch. Stop
exactly at the stop mark.
The computer counts pulses received whilst driving.
4 Press the ENTER key and forward speed calibration is finished.
IMPLEMENT SENOR
The implement sensor “tells” the computer whether area should be counted or not.
Each time the implement sensor is activated the tramlining bout number increases
by 1.
Key Description
Pressing this key (program key 1) selects the implement signal
coming from the 7-pin DIN/ISO socket in the tractor.
Pressing this key (program key 2) selects the implement signal from
a sensor fitted on the seed drill.