Tie Down Turbo Lube - Manual (Page 4)

Fill Level
Proper Fill Level
Apply Here
Apply Here
Stainless Steel
Wear Sleeve
Spindle
Transparent Oil Cap,
view current oil level
Seal
Bearing Bearing
Cups
Spindle
Nut
Cotter
Pin*
Oil Plug
Turbo
Lube
Cap
O-Ring
Flange
Lock*
Thurst
Washer
O-Rings
* Hub kit contains either
cotter pin or flange lock
50 WT.
Oil
4
Turbo Lube Hub (Top Fill/Hub Fill) Bearing Lubrication/Maintenance
1. Remove oil filling plug from Turbo Lube Cap/Hub. Add oil into the Turbo Lube Hub.
2. Add oil (2.5 - 3 oz.) until oil level is appropriately half full on the see through oil
cap (up to MAX FILL line). Some time should be given to allow oil to pass through
the bearings and level off.
DO NOT OVER FILL.
3. Replace oil filling plug.
4. Check oil level. Add oil if necessary (repeating step 1,2 & 3) to maximum fill level
on the see-through oil cap.
DO NOT OVER FILL.
5. Mount tire/wheel.
6. Check oil level in the Turbo Lube Hub before each trip. Add oil if required to
“MAX FILL” line on cap.
NOTE: It is normal for the oil to change color after a few miles of use. Even a
small amount of moisture condensation can cause the oil to turn milky.
Materials needed: 50w Oil (min.) 90 Weight Gear (max.) Oil Recommend.
50w synthetic is preferred, any quality brand oil is OK.