Tie Down Turbo Lube - Manual (Page 8)

NOTE: If you have stainless steel wear sleeves, use the following instructions:
When installing turbo lube hubs on an existing axle that has stainless steel wear
sleeves, apply a high temperature silicone sealant like “RTV” (NOT INCLUDED) to the
inside and outside area where the seal meets the spindle surface. Allow sealant to
fully “CURE” before assembly. This must be done to prevent potential oil leakage under
the wear sleeve.
Fill Level - Bottom of file hole
Seal
Bearing Bearing
Cups
Spindle
Nut
Cotter
Pin*
Oil Plug
Turbo
Lube
Cap
O-Ring
Flange
Lock*
Thrust
Washer
* Hub kit contains either cotter
pin or flange lock
O-Ring
Oil Cap, View
current oil level
Oil filling plug, no
need to remove cap
Triple lip, spring
loaded oil seal
Completely sealed oil
reservoir chamber permits
maximum lubrication
Apply Here
Apply Here
Stainless Steel
Wear Sleeve
Spindle
Stainless Steel Wear Sleeve Instructions
TIE DOWN ENGINEERING, Inc.
255 Villanova Drive SW, Atlanta, GA 30336
www.tiedown.com
(404) 344-0000 • Fax (404) 349-0401
© 2008 TIE DOWN ENGINEERING, ALL RIGHTS RESERVED