Tie Down Turbo Lube - Manual (Page 5)

5
Turbo Lube Hub (Top Fill) Installation/Replacement Instructions
Fill Level
Proper Fill Level
Apply Here
Apply Here
Stainless Steel
Wear Sleeve
Spindle
Transparent Oil Cap,
view current oil level
Seal
Bearing Bearing
Cups
Spindle
Nut
Cotter
Pin*
Oil Plug
Turbo
Lube
Cap
O-Ring
Flange
Lock*
Thurst
Washer
O-Rings
* Hub kit contains either
cotter pin or flange lock
50 WT.
Oil
1. Remove wheel from hub.
2. Remove hub dust cap, cotter key or flange washer, spindle nut and thrust washer.
3. Remove old hub from spindle.
4. Wipe spindle clean, check for any noticeable wear or rust.
NOTE: Excessively worn seal surface can allow moisture to enter the hub
5. Assemble new hub. Set bearings as shown, if not already pre-assembled.
6. Place a thin coating of oil or grease on spindle surface. Mount Turbo Lube Hub.
7. Tighten the spindle nut with a 1/2 inch torque wrench to approximately 40 ft. lbs.
Turn wheel in both directions to confirm wheel turns freely.
8. Turn back spindle nut 1/6 turn maximum to the nearest cotter key or flange washer
locking position. Wheel should turn smoothly with no end play or wobble.
9. Place the Turbo Lube O-ring over the threaded portion of the Turbo cap.
10. Install oil cap, turn clockwise, snug by hand and then turn 1/4 additional turn.
Do not over tighten. See back diagram.
Fill Level
Proper Fill Level
Apply Here
Apply Here
Stainless Steel
Wear Sleeve
Spindle
Transparent Oil Cap,
view current oil level
Seal
Bearing Bearing
Cups
Spindle
Nut
Cotter
Pin*
Oil Plug
Turbo
Lube
Cap
O-Ring
Flange
Lock*
Thurst
Washer
O-Rings
* Hub kit contains either
cotter pin or flange lock
50 WT.
Oil
Hand tighten cap until snug. Use wrench to
turn an addition 1/4 turn. Check to make sure
that the O-rings are seated properly. Be
careful not to over tighten. Check oil level,
fill if necessary. Tighten oil plug cap.