Tie Down Turbo Lube - Manual (Page 6)

Turbo Lube Hub (Front Fill) Bearing Lubrication/Maintenance
Fill Level - Bottom of file hole
Seal
Bearing Bearing
Cups
Spindle
Nut
Cotter
Pin*
Oil Plug
Turbo
Lube
Cap
O-Ring
Flange
Lock*
Thrust
Washer
* Hub kit contains either cotter
pin or flange lock
O-Ring
Oil Cap, View
current oil level
Oil filling plug, no
need to remove cap
Triple lip, spring
loaded oil seal
Completely sealed oil
reservoir chamber permits
maximum lubrication
Apply Here
Apply Here
Stainless Steel
Wear Sleeve
Spindle
1. Remove oil filling plug from Turbo Lube Cap. Add oil into the Turbo Lube Hub.
2. Add oil until oil level is just below the filler hole. Some time should be given to allow
oil to pass through the bearings and level off.
3. Replace oil filling plug.
4. Check oil level. Add oil if necessary (repeating step 1,2 & 3).
5. Mount tire/wheel.
6. Check oil level in the Turbo Lube Hub before each trip. Add oil if required to the
bottom of the filler hole on cap.
NOTE: It is normal for the oil to change color after a few miles of use. Even a
small amount of moisture condensation can cause the oil to turn milky.
Materials needed: 50w Oil (min.) 90 Weight Gear (max.) Oil Recommend.
50w synthetic is preferred, any quality brand oil is OK.
6