Tii FDH1 - Manual (Page 13)

13 Tii Network Technologies Inc. 2012
9.9. Typical PON
9.9.1. Install each MDU home run drop cable to rear patch panel, label as required.
9.9.2. Top most adapter plate for feeder cable high power pass-through and splitter connections.
9.9.3. Splice feeder fiber(s), field terminate or install stub as required rear side of top adapter plate.
9.9.4. Install splitter housing to rear panel using alignment stud and Velcro.
9.9.5. Route splitter legs to front side patch panel.
9.9.6. Install splitter input (blue strand) to top adapter plate feeder cable.
9.9.7. Install splitter outputs (yellow strands) to parking lot.
9.9.8. Activate MDU connections by moving from parking lot to dwelling ports as required.