Tii FDH1 - Manual (Page 5)

5 Tii Network Technologies Inc. 2012
FIGURE 1a. Basic Layout
5. FDH1 Cabinet
5.1. The Tii FDH1 Series Cabinet can be configured in three (3) versions including an all patch version, a
patch and splice version and a PON Version.
5.2. Figures 1 and 1a shows the general features of the FDH1.
5.3. The all patch version, shown in figures 1 & 1a, is equipped with LGX plates modular adapter plates (in
6, 8 or 12 adapters) for either24, 32 or 48 patch only configurations. This version assumes the use of
pre-stubbed drops with fan-out or field installable connectors on both input and output.
5.4. The unit also is equipped with 1 single LGX modular adapter plate for pass through fiber (where
applicable).
6. Patch and Splice
6.1. Shown in figure 2, is equipped with LGX plates modular adapter plates (in 6, 8 or 12 adapters) for
either24, 32 or 48 patch configurations and is equipped with up to four (4) splice trays.
6.2. One (1) to accommodate the feeder fiber and three (3) to accommodate splicing of the distribution
fibers.
6.3. Optionally the LGX adapters may be ordered with 6, 8 or 12 fiber pigtail assemblies, per-installed into
the spice trays. The pigtails may also be purchased separately.
Fiber Slack Storage
Top Entry Ports