Vermont Casting IRHEDV32 - Manual (Page 20)

10003929
TRIM ASSEMBLY
1. Install trim channels (left and right sides). Use two
screws to assemble each piece.
2. Slide on the trim top channel and fasten it from the
back side.
3. Install the trim top deflector and use two screws to
fasten it. (Fig. 26)
4. Remove ALL plastic protective covering from brass trim.
RHEBSL
Fig. 26
To install the kit you do not have to remove any piece
of brass, you just add the external pieces.
Remove the frame trim from the unit if it is already
installed.
1. Install trim channels (left and right sides)by removing
the two screws that hold the side brass trim and put
them back to hold both parts.
2. Slide on the trim top channel and fasten it from the
back side.
3. Remove the two screws that hold the top brass trim.
4. Install the two brackets to the studs in the bottom of
the top channel. Use the nuts supplied with the kit.
5. Reinstall the two screws to hold the top trim channel.
RHEBXL
A2) RHEBSL & RHEBXL TRIMS
KEY DESCRIPTION RHEBSLP RHEBSLA RHEBXLP (1) RHEBXLA (1)
1 Trim Frame Flat Black 57926 57926 - -
2 Trim Top Deflector 17634-PB 17634-AB - -
3 Trim Top Channel 57864 57844 - -
4 Trim Side Channel 57862 57843 - -
5 Trim Outer Top Channel - - 57861 57845
6 Trim Outer Side Channel - - 57863 57846
7 Fasteners Package (Not Shown) 54618 54618 57633 57633
TRIM REPLACEMENT PARTS LIST
(1) RHEBXLP or RHEBXLA to be used with RHEBSLP or RHEBSLA trims.
(2) SL trim dimensions are for openings smaller than 27 1/2 "H x 40 1/2 " W (700mm x 1030mm)
(4) XL trim dimensions are for openings smaller than 30"H x 45 5/8 " W (765mm x 1160mm)
ALL repair parts will be available from your local dealer.
When ordering, always give the following information: Model and serial number, part description with finish and part number;
20
Side View
Trim Frame Top Section
Trim Top Deflector
5
3
6 4 6 4
1
2