Vermont Casting 36XDV - Manual (Page 29)

10009383 29
XDV Direct Vent Gas Fireplace
NOTE: Refer to Figure 56 for bracket and bend loca-
tions.
1. Place the log front right. Hold the log with the pointed
end toward the left. Place on top of burner toward
the right. Slide the log toward the front until it comes
in contact with the bracket at the front of the burner
housing behind the burner tube. (Fig. 58) Adjust the
log until the pointed end on the left is aligned with
the left edge of the bracket. (Fig. 59)
������
���������������
����
Stop
Bracket
Rear Log Bracket
Front Brackets
FP1607
Fig. 58 Burner brackets and bends.
Left Edge
of Bracket
39XDV
�����
��������������
�����
Log Overlay
LG479
Figure 60
2. Place the log overlay. Hold the overlay
with the flat side down and large cut out
for the middle flame on the right. Set the
overlay on top of the burner toward the
left front inside the stop bracket on the
left end and the bend on the front left
of the burner. (Fig. 60) Rotate the
right end of the overlay clockwise
until it makes contact with the back
of the log front right. NOTE: This is
very critical as improper
positioning of the over-
lay will affect the flame
and the performance of the unit.
(Fig. 60)
�����
�����������������
����
LG478
Figure 59
Log Front Right