Cisco 7931G - Manual (Page 11)

4-11
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 6.1
OL-14587-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Network Configuration Menu
TFTP Server 2 Optional backup TFTP server that the
phone uses if the primary TFTP server is
unavailable.
If neither the primary TFTP server nor
the backup TFTP server is listed in the
CTL file on the phone, you must unlock
the CTL file before you can save changes
to the TFTP Server 2 option. In this case,
the phone will delete the CTL file when
you save changes to the TFTP Server 2
option.
For information about the CTL file, refer
to Cisco Unified Communications
Manager Security Guide. For
information about unlocking the CTL
file, see to the
“Security Configuration
Menu” section on page 4-37 .
1. Unlock the CTL file, if necessary.
2. Unlock network configuration
options.
3. Enter an IP address for the TFTP
Server 1 option.
4. Scroll to the TFTP Server 2 option,
press the Edit softkey, and then enter
a new backup TFTP server IP
address.
5. Press the Validate softkey, and then
press the Save softkey.
Default Router 1
Default Router 2
Default Router 3
Default Router 4
Default Router 5
Default router used by the phone
(Default Router 1) and optional backup
routers (Default Router 2–5). 1. Unlock network configuration
options.
2. Set the DHCP Enabled option to No.
3. Scroll to the appropriate Default
Router option, press the Edit
softkey, and then enter a new router
IP address.
4. Press the Validate softkey.
5. Repeat Steps 3 and 4 as needed to
assign backup routers.
6. Press the Save softkey.
Table 4-2 Network Configuration Menu Options (continued)
Option Description To Change