VACUUBRAND CVC 2II - Manual (Page 8)

page 8 of 36
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. manual-no.: 997835 / 15/12/2009
Keys
Rear side
mains switch
male connector for
mains cable thread M8 for stand rod
(included) female connector to connect valves and vacuum
management system VMS Module A
(use Y-socket-plug connector if necessary)
VENT
START
STOP
MODE
p ΔΔΔΔΔ p
- start or stop of process control
- confirmation of selected values
- switching between two-switch-point control and continuous pumping
- special function (in combination with an additional key)
- setting of set point p
- switching in programs
rating plate vacuum connection air admittance valve:
air inlet/inert gas
connection
setting of hysteresis
Δp or
time t for switch-off
operating the built
in air admittance
valve
CVC 2 II