Veracity CAMSWITCH QUAD (Superceded by CAMSWITCH 4 PLUS) User Manual
Veracity Accessories for video
Where to use CAMSWITCH QUAD
CAMSWITCH QUAD is a network switch designed especially for
security and IP video network installations.
CAMSWITCH QUAD integrates the following features into a
single, compact device:
10/100 unmanaged network switch
Four auto-configuring network ports with Power Over
Fifth auto-configuring port for “downlink” connection
Safe POE power management
Unique, auto-configuring DC or AC power input
Rugged, wall-mountable enclosure
In the example shown above, CAMSWITCH QUAD provides all
four remote cameras with both their POE power supply and an
Ethernet connection. Power for all cameras and the
CAMSWITCH QUAD is sourced from a single low voltage AC or
Connections to the CAMSWITCH QUAD are as shown:
Please read the installation instructions overleaf carefully before
installing your CAMSWITCH QUAD.
10 / 100 Ethernet ports with POE
EC Declaration of Conformity
In accordance with EN 45014:1998
We, Veracity UK Ltd. of
6 Barns Street, Ayr, KA7 1XA
declare that the equipment “CAMSWITCH QUAD” POE Network Switch
model number VCS-CSQ
conforms to the essential protection requirements of the EMC Directive
89/336/EEC as amended. The following EMC standards have been applied:
BS EN 55022:1998 Emissions (Class B Radiated)
BS EN 55024:1998 Immunity (BS EN 61000-4-2:1995 Immunity to ESD,
BS EN 61000-4-3:2000 Immunity to Radiated RF Fields (3V/m))
I hereby declare that the equipment named above has been been found to
comply with the relevant sections of the above referenced specifications.
The unit complies with all essential requirements of the EMC Directive.
Mr Alastair McLeod, Director
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
AC or DC power
10 / 100 Ethernet