Cisco 3560 - Manual (Page 25)

1-15
Catalyst 3560 Switch Hardware Installation Guide
OL-6337-07
Chapter 1 Product Overview
Rear Panel Description
Dual-Purpose Port LEDs
The LEDs on a dual-purpose port (see Figure 1-13 ) show whether the RJ-45 connector is connected or
whether an SFP module is installed. You can configure each port as either a 10/100/1000 port through
the RJ-45 connector or as an SFP module, but not both at the same time. The LEDs show how the port
is being used.
The LED colors have the same meaning as described in Table 1-4 to Table 1-6 .
Figure 1-13 Dual-Purpose Port LEDs
Cable Guard
You can order an optional cable guard to secure cables to the front of the switch and prevent them from
being accidentally removed. To order a cable guard (CBLGRD-C3560-12PC or CBLGRD-C3560-8PC),
contact your Cisco representative. The cable guard serves a different purpose than the cable guide (see
“Attaching the Cable Guide” section on page 2-11 ).
Rear Panel Description
• Internal Power Supply, page 1-18
• Cisco RPS, page 1-19
• Console Port, page 1-19
• Security Slots, page 1-20
Note The Catalyst 3560-8PC and the Catalyst 3560-12PC-S switches do not have an RPS connector or a fan.
The switch console port is on the front panel.
1 RJ-45 connector 3 SFP module port LED
2 RJ-45 port LED 4 SFP module slot
1
4 1 2 3