Wall-mounting, Attaching the rps connector cover, page 2-13, Mounting the switch on a wall, page 2-14 – Cisco 3560 User Manual

Page 44: 1phillips truss-head screws

Advertising
background image

2-12

Catalyst 3560 Switch Hardware Installation Guide

OL-6337-07

Chapter 2 Switch Installation (24- and 48-Port Switches)

Installing the Switch

Wall-Mounting

These switches wall-mount only with the front panel facing up:

Catalyst 3560-24PS, 3560-24TS-S, 3560-48PS, and 3560-48TS-S

Catalyst 3560G-24PS, 3560G-24TS, 3560G-48PS, and 3560G-48TS

These switches wall-mount with the front panel facing up or down:

Catalyst 3560V2-24PS, 3560V2-24TS, 3560V2-48PS, and 3560V2-48TS

The illustrations in this section show the Catalyst 3560G-48PS switch as an example.

Caution

You must install the RPS connector cover before wall-mounting the switch.

Warning

Read the wall-mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system.
Statement 378

To install the switch on a wall, follow the instructions in these procedures:

Attaching the Brackets to the Switch for Wall Mounting, page 2-12

Attaching the RPS Connector Cover, page 2-13

Mounting the Switch on a Wall, page 2-14

Attaching the Brackets to the Switch for Wall Mounting

Figure 2-10

shows how to attach a 19-inch bracket to one side of the switch. Follow the same steps to

attach the second bracket to the opposite side.

Figure 2-10

Attaching the 19-inch Brackets for Wall Mounting

1

Phillips truss-head screws

40

41

42

43

44

45

46

47

48

47X

48X

97925

Catalyst 3560

SERIES

PoE-48

1

2

3

4

1

Advertising