Securing the ac power cord – Cisco 3560 User Manual

Page 75

Advertising
background image

3-19

Catalyst 3560 Switch Hardware Installation Guide

OL-6337-07

Chapter 3 Switch Installation (8- and 12-Port Switches)

Installing the Switch

Securing the AC Power Cord

The AC power-cord retainer is an optional part (PWR-CLIP-CMP).

Step 1

Insert the power-cord retainer wire into the slot on the plastic holder.

Step 2

Attach the plastic holder onto the switch rear panel with the supplied screw (see

Figure 3-11

).

Figure 3-11

Insert the Power-Cord Retainer

Step 3

Rotate the wire to the right side of the AC power cord connector, and insert the AC power cord (see

Figure 3-12

).

Figure 3-12

Insert the AC Power Cord

Step 4

Place the power cord bushing on the power cord with the opening at the top. The retainer wire only fits
into one slot on the bushing. Move the retainer wire into the bushing slot (see

Figure 3-13

).

Figure 3-13

Attach the Power-Cord Bushing

Step 5

Slide the bushing so that it rests against the power-cord connector, and then rotate the bushing clockwise
until the bushing is securely fastened and its opening is on the right side of the power cord (see

Figure 3-14

).

250519

250520

250521

Advertising