Vizualogic RoadTrip Elite 8 - Manual (Page 19)

18
Rear-Seat Entertainment
Installation Step
Ins tallation and Conn ections
console box first.
※For example:
The console box is 15(W) x 25(H) cm. (Figure 1)
Measure the width and height of the
Adjust the width of the transverse axle.
※
The width of the console box is 15cm. (Figure 1)
According to the width of the Center Console Box
to pull out and adjust the suitable width of the
transverse axle. (Figure 2)
For example:
1
(Figure 1)
2
Choose suitable Plastic Washer.
Check both sides of the center console, if it have
slope, please choose suitable plastic washer
(the thick oblique washer/ thin oblique washer/
flat washer) and make the brackets perpendicular
to 90 degrees. (Figure 3)
3
(Figure 3)
Plastic Washer
90 degrees
3~5cm
Mark the screw positions of the disc holder.
After decided the installation angle of the bracket,
please mark the screw positions of the disc holder,
in the both side of console box. (Figure 4)
After that, drill four 4 holes in the both side of
console box.
4
(Figure 3-2)
(Figure 2)