Wilkerson DE2 - Manual (Page 6)

1. IMPORTANT! No overload protection is provided in the dryer and unit should be
wired into a protected circuit. A knockout hole is provided for electrical connection.
2. The dryer can be grounded by attaching a ground wire to the timer assembly bracket
screw. See wiring diagram.
G. Solid State Timers – The solid state timers used in the DE series dryers permit the
simultaneous switching of the solenoid valves every 30 seconds. The timers are equipped
with a one hour memory capability. If power is interrupted, the dryer will resume operation
at the same point in the cycle when power is restored.
Wiring Diagram
Figure 4
Instruction Manual / DE0, DE1 and DE2
Wilkerson Compact Heatless Air Dryers
!