Winco ULPSS12H4W/E - Manual (Page 13)

3 075-00 60706-208
INITIAL START UP
******************
***** WARNING *****
******************
DO NOT jump start these generator sets. Starting
these units on a low battery by jump starting them
will cause damage to the engine control module.
Use the following checklist to verify correct in-
stallaion before starting the engine:
� Engine oil. Check level & fill as required with
proper grade/quantity. Refer to engine owners
manual for proper levels and types.
� Unit mounting base properly bolted down.
� Clearance for service and maintenance on all
sides.
� Proper fuel line material and size.
� All fuel line connections tight.
� Fuel line protected and a moisture trap in
stalled (may be required for NG).
� LP/NG pressure OK. 4-6 oz. (7- in. WC).
� Battery connections clean and tight.
� Battery fully charged.
� All AC and DC wiring installed and properly
protected.
After completing the above checklist, the generator
set is ready for the initial start-up test.
START UP PROCEDURE
Engine Generator Set only
Move the left hand toggle switch from OFF to the
ON position. The alarm light should go out. Next
move the right hand toggle witch from the AUTO to
the RUN position. You should hear the fuel solenoid
engage at this time. Next lift the toggle switch to the
START position and hold. The engine starter should
engage and the engine will start. As soon as the en-
gine starts release the toggle switch and it will return
to the run position. If the engine does not start after
5 seconds release the switch and let the starter rest
for 5 seconds and re-attempt to start. If the unit still
will not start, consult the troubleshooting guide in the
back of this manual.
WIRE # PURPOSE RECOMMEND
COLOR
# 5 Battery Positive Black
# 1 Battery Negative White
# 24 Fuel Solenoid Red
# 22 Start Orange
These wire colors are a recommendation only. The
wires terminate on TB7 as follows:
WIRE # COLOR TB7 TERMINAL
# 5 Black # 3
# 1 White # 2
# 24 Red # 4
# 22 Orange # 7
Jumpers will need to be installed as follows:
WIRE # COLOR TB7 TERMINAL
# 5 Black # 3 & # 5
# 5 Black # 5 & # 8
The following is an optional way to interconnect the
Generator and the Transfer Switch. the wires termi-
nate on TB7 terminal as follows:
WIRE # COLOR TB7 TERMINAL
# 1 White # 2
# 24 Red # 4
# 22 Orange # 7
The following leads are wire-nutted together:
WIRE # COLOR FROM
# 5 Black Generator
# 5 Black TB7 # 3
# 5 Black TB7 # 5
#5 Black TB7 # 8