Winco DGC-2020 - Manual (Page 32)

2-6 DGC-2020 Human-Machine Interface 9400200990 Rev K
ALARMS-STATUS
 ALARMS
 PRE-ALARMS
 MTU FAULT CODES (Visible when ECU is configured for MTU MDEC, MTU ADEC, or MTU ECU7.)
 MTU STATUS (Visible when ECU is configured for MTU MDEC, MTU ADEC, or MTU ECU7.)
 STATUS
o EPS SUPP. LOAD
o GEN BREAKER
o MAINS BREAKER
o GRND DELTA O-RIDE
o GEN DEAD
o GEN STABLE
o GEN FAILED
o BUS DEAD
o BUS STABLE
o BUS FAILED
o EXT START DEL
o START DEL BYPASS
o COOLDN REQ
o COOL STOP REQ
o OFF MODE COOLDN
 INPUTS
o INPUT X (X = 1 to 16, (17 to 26 optional))
 OUTPUTS
o OUTPUT X (X = 1 to 4, (5 to 36 optional))
 ANALOG INPUTS
o SCALED
 ALG_IN_X (X = 1 to 8)
o RAW
 ALG_IN_X (X = 1 to 8)
 THERMAL INPUTS
o SCALED
 RTD_IN_X (X = 1 to 8)
 THRM_CPL_X (X = 1 to 2)
o RAW
 RTD_IN_X (X = 1 to 8)
 THRM_CPL_X (X = 1 to 2)
 ANALOG OUTPUTS
o SCALED
 ALG_OUT_X (X = 1 to 4)
o RAW
 ALG_OUT_X (X = 1 to 4)
 ANALOG STATUS
 CONF ELEMENTS
 CONF PROT STATUS
 EVENT LOG
o EVENT
 ACTIVE
 OCCURRENCE
COUNT
 FIRST DATE
 FIRST TIME
 LAST DATE
 LAST TIME
 FIRST ENG HRS
 LAST ENG HRS
 DETAILS

OCCURRENCE (Use the Edit/Up/Down keys to change the occurrence.)
 DATE
 TIME
 ENG
HRS
 J1939 DATA (Visible when ECU is configured for Standard or Volvo Penta.)
 J1939 ENGINE CONFIG (Visible when ECU is configured for Standard or Volvo Penta.)
 J1939 ACTIVE DTC (Visible when any ECU type is selected.)
 J1939 PREV DTC (Visible when any ECU type is selected.)