Winco DGC-2020 - Manual (Page 39)

9400200990 Rev K DGC-2020 Human-Machine Interface 2-13
o MAINTENANCE INTERVAL
 ENABLE
 THRESHOLD
o BATTERY OVERVOLTAGE
 ENABLE
 THRESHOLD
o LOW BATTERY VOLTAGE
 ENABLE
 THRESHOLD
 ACTIVATN
DLY
o WEAK BATTERY VOLTAGE
 ENABLE
 THRESHOLD
 ACTIVATN
DLY
o HIGH FUEL LEVEL
 ENABLE
 THRESHOLD
 ACTIVATN
DLY
o CHECKSUM FAIL
 ENABLE
o ACTIVE DTC (Visible when DTC is enabled.)
 ENABLE
o ECU COMMS FAIL (Visible when CANBUS is enabled.)
 ENABLE
o COOLANT LEVEL (Visible when CANBUS is enabled.)
 ENABLE
 THRESHOLD
o AVR OUTPUT LIMIT (Visible when LSM-2020 is enabled.)
 ENABLE
 ACTIVATN
DLY
o GOV OUTPUT LIMIT (Visible when LSM-2020 is enabled.)
 ENABLE
 ACTIVATN
DLY
o INTERGENSET COMM FAIL (Visible when LSM-2020 is enabled.)
 ENABLE
o LSM COMM FAIL (Visible when LSM-2020 is enabled.)
 ENABLE
o CEM COMM FAIL (Visible when CEM-2020 is enabled.)
 ENABLE
o AEM COMM FAIL (Visible when AEM-2020 is enabled.)
 ENABLE
o ID MISSING (Visible when LSM-2020 is enabled.)
 ENABLE
o ID REPEAT (Visible when LSM-2020 is enabled.)
 ENABLE
 ALARMS
o HIGH COOLANT TEMP
 ENABLE
 THRESHOLD
 ARMING
DELAY
o LOW OIL PRESSURE
 ENABLE
 THRESHOLD
 ARMING
DELAY
o LOW FUEL LEVEL
 ENABLE
 THRESHOLD
 ACTIVATN
DLY
o OVERSPEED
 ENABLE
 THRESHOLD
 ACTIVATN
DLY
o COOLANT LEVEL (Visible when CANbus in enabled.)
 ENABLE
 THRESHOLD