Winco DSE7000 Quick Start Guide - Manual (Page 20)

DSE Model 7000 Series Quick Start Guide
20 Part No. 057-101 7000 Series Quick Start Guide ISSUE 1 14/04/2009 JR
4.4.3 ENGINE RUNNING
Once the engine is running, the Warm Up timer, if selected, begins, allowing the engine to stabilise before accepting
the load.
Load will be automatically transferred from the mains supply to the generator.
NOTE:-The load transfer signal remains inactive until the Oil Pressure has risen. This prevents
excessive wear on the engine.
In test mode, the set will continue to run on load until either:
•
The stop button is pressed – The set will immediately stop
•
The auto button is pressed. The set will observe all auto mode start requests and stopping timers
before beginning the Auto mode stopping sequence.