Winco Mfg. 8910SH - Bariatric Treatment Table User Manual

Bariatric treatment table

Advertising
background image

Page 1 of 4

006190

REV O Date 06-06-12

JWC



1.

READ AND FOLLOW ALL DIRECTIONS.

2.

NEVER stand on table or INJURY MAY OCCUR.

3.

NEVER allow user to sleep unattended on table or INJURY MAY OCCUR.

4.

NEVER leave an unconscious user unattended on table or INJURY MAY OCCUR.

5.

DO NOT use table for transporting user in or with ANY type of vehicle or trailer. Winco tables have not been tested
or approved for use by an occupant in any type of vehicle or trailer.

6.

NEVER leave an infant or child unattended on table or INJURY MAY OCCUR.

7.

DO NOT put hands, feet or clothing into any openings when changing user positions on table. Attendant MUST
confirm that users hands and feet are clear of openings when changing positions or INJURY MAY RESULT.

8.

Periodically, recheck tightness of all nuts, bolts and screws.

9.

USE ONLY WINCO AUTHORIZED REPLACEMENT PARTS.

10. NEVER EXCEED the recommended weight capacity of 1000 lbs. (453.6 kg).
11. SAVE THESE INSTRUCTIONS for future reference and training.

8900-8910

Bariatric Treatment Table



CUSTOMER INSTRUCTIONS
























Tools needed:

 Phillips-head

screwdriver

 7/16” wrench, (multiple size wrench included)

 Scissors or box cutter

 Cardboard shipping container (stays under table during assembly to protect upholstery)

 - If using powered tools always start hardware together by hand first & wear safety goggles


SEE “Parts Guide & List” (pg.3) for visual reference during assembly.

1.

After checking your product for any shipping damage, table needs to be positioned upside-down on cardboard
or protective surface. Remove all packing material and hardware that was secured for shipping. Cut tape on
corners of box so that cardboard will lay flat while you assemble table.

Leg Assemblies (3):

2.

You will find (3) Table Legs, in-between or attached-to the Table Frame Rails. Pivot up the (2) Table Legs
on ends of table (see photo). Insert (2) ¼-20 x 2” screws through (2) holes in each Upper Leg Brace and into
(2) threaded holes in the wood of the Upholstered Top.

NOTE:
Upper Leg Braces on all Table Legs have (2) holes that need to align with two threaded holes in the
wood of the Upholstered Top
.

The center Table Leg must have two sets of holes aligned. Holes in the Upper Leg Brace of the Table Leg
must align with holes in the bottom of table, AND the oval-shaped holes on the legs must align with holes on
both frame rails on the table.

The center Table Leg may need to be rotated 180 degrees so that the above alignment is possible.

PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE PROCEEDING WITH ASSEMBLY

PLEASE READ AND FAMILIARIZE YOURSELF WITH ALL INSTRUCTIONS BEFORE USING THIS PRODUCT.

If you have trouble understanding these instructions contact your dealer or Winco customer support, (800) 237-3377

before attempting to use this product; otherwise injury may occur.

Winco assumes no responsibility for damage or injury caused by improper assembly,

installation, use, or maintenance of these products.

8900-8910 Weight Capacity = 1000 lbs. (453.6 kg.)

Advertising