Zapco Z-series D - Manual (Page 10)

GND REM B+ SPK B SPK A
SPEAKER OUTPUTS POWER INPUT
GND REM B+ SPK B SPK A
SPEAKER OUTPUTS POWER INPUT
Using a dual amplifier configuration, the MASTER amplifier has total control over the SLAVE amplifier.
When using dual amplifier to operate subwoofer, the positive terminal of the subwoofer's voice coil must
be connected to the positive terminal of the MASTER Amplifier and the negative terminal of the
subwoofer's voice coil must be connected to positive terminal of the SLAVE Amplifier. Be advised that
the dual amplifier configuration has very high output potential, so be sure that your subwoofers can
handle the power.
In strapped mode your total impedance must be at least 2 ohms, any impedance less than
2 ohms could possibly damage your amplifiers
Caution
Use 8 Gauge(AWG) wire cable
"MASTER UNIT"
"SLAVE UNIT"
2~8
ohms
DUAL AMP SPEAKER CONNECTION
Z-1KD / Z-2KD / Z-3KD
to REMOTE Turn-on
from HEAD UNIT
GROUND
BATTERY HEAD UNIT GROUND
to REMOTE Turn-on
from HEAD UNIT
GROUND
BATTERY HEAD UNIT
GROUND
-9-